Cutting Plywood Correctly
• DIY
1. Avoid Cross Cutting - Plywood tends to chip the most when cut across its width (grain). Cutting along the length of the wood will help to reduce chipping.
2. Use the Right Blade - Special blades are manufactured for different cutting jobs. The number of teeth, width, angle, and rake of the blade all impact the cut. Choose a blade that best matches your specific cutting situation.
3. Circular Saw - cut with the “best face” down.
4. Table Saw - cut with the “best face” up.
5. Score the Cut First - Run the plywood through the saw removing only a minimal amount of wood. The next cut will leave a cleaner cut.
6. Masking Tape - Put masking tape over the cut line to help keep the fibers on the edge from pulling up.
7. Backing Panel - Attach a backing panel with strong double stick tape. The backer board will take the brunt of the damage.
8. Use a Router - A router fitted with a straight bit will cut a clean line. A pilot bit and straight edge will help provide a clean line.
9. Score with a Utility Knife - Score the cut line with a utility knife.
10. Buy a Panel Scoring Setup - Some saws can be fitted with a plywood panel scoring setup and are ideal if you have to cut a lot of plywood. The setup consists of a smaller blade that scores the surface of the plywood before it reaches the cutter.
Brought To You Courtesy: Cedar Creek Woodshop